LG HT353SD-A2 Manual De Servicio página 53

SCK/SCL
SI/I2C_AD0
/CS/I2C_AD2
EXT_MUTE
OVERLOAD
EPD_ENA
TEST_MODE1
TEST_MODE2
SCAN_ENA
TEST_MODE3
All inputs and bi-directional inputs are 5 Volt tolerant. The corresponding pins can be connected to the buses that can
swing between 0V and 5V. The output-only pins are not 5V tolerant and the buses they are connected to can swing only
between 0V and 3.3V.
Sólo para uso interno de LGE
79 I SCK for SPI mode or SCL for I2C mode.
Schmitt-Trigger input.
82 I SI for SPI mode or Slave Address 0 for I2C mode.
Schmitt-Trigger input.
Internal pull-down resistor.
83 I Chip selector (CS) for SPI mode or Slave Address 2 for I2C
mode.
Schmitt-Trigger input.
Internal pull-down resistor.
Special Control Interface
27 I External mute control input. Active High.
Assert 'HIGH' to mute audio output.
Internal pull-down resistor.
76 I Power stage overload indication input.
Polarity is programmable. Schmitt-Trigger input.
When OVERLOAD is asserted, all PWM audio outputs go to
"LOW". That shutdown process is programmable.
Internal pull-down resistor.
77 O External amplifier power device enable output. Active High.
Test Mode
97 I Test mode selection pin 1.
In normal operation, it should be "LOW" or not connected.
Internal pull-down resistor.
98 I Test mode selection pin 2.
In normal operation, it should be "LOW" or not connected.
Internal pull-down resistor.
99 I Scan enable. Active High.
In normal operation, it should be "LOW" or not connected.
Internal pull-down resistor.
100 I Test mode selection pin 3.
In normal operation, it should be "LOW" or not connected.
Internal pull-down resistor.
2-44 Copyright © 2008 LG Electronics. Inc.Todos los derechos reservados.
Sólo con fines de capacitación y mantenimiento