Genius RCU1 Manual Del Usuario página 13

STAGE 3: START-UP AND TESTS
OPEN THE
DOOR
DIP-SWITCHES
from 1 to 12
PUSH-
BUTTON 1
PUSH-
BUTTON 2
• Dip-switches from 1 to 11 are positioned according to the adjustments required of the 4 functions.
• Release the motors, take the gate to 45°, and re-lock.
• Press PUSH-BUTTON 1 to transmit these adjustments to the electronics.
• The cycle will start according to the adjustments.
• Check if the gate opens;
IF IT DOES NOT OPEN, press PUSH-BUTTON 1, to stop the cycle (consult paragraph: 1st start-up, on
page 12).
IF IT DOES OPEN, allow the cycle to finish, and continue adjusting until you obtain the required
operation.
TO MODIFY THE ADJUSTMENTS OF THE FUNCTIONS, PRESS PUSH-BUTTON 1.
YOU CAN MODIFY ONE OR MORE ADJUSTMENT PARAMETERS AT ANY TIME - JUST SET
THE PROGRAMMING MODE
PROGRAMMING
STAGE 4: RADIO CODE
ON
OFF
11
1___________8 9____12
Position DIP-SWITCHES 9, 10, 11 to ON and 12 to OFF.
Position dip-switches from 1 to 8 in any position.
This is your personal code.
Press the selected push-button to transmit the radio code.
This push-button will control the automated system.
Allow the cycle to finish until the gate closes.
• TURN OFF MAINS POWER.
• RELEASE LK1 JUMPER.
• TURN ON AGAIN MAINS POWER.
The automated system is ready to operate. You can modify one or more adjustment parameters
at any time - just set the programming mode.
Press PUSH-BUTTON 1 in programming mode.
HOW TO ADD A REMOTE-CONTROL:
F
OR ONE OR MORE ADDITIONAL REMOTE
12 DIP-SWITCHES
THE IN THE SAME POSITION AS THOSE OF THE FIRST REMOTE
O N
OFF
Use mode
- ,
CONTROLS JUST POSITION
ENGLISH
- .
CONTROL