Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Always wear SAFETY GLASSES
when installing hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
Fasteners
typical
both sides
Teeth side
against hitch
Figure 3
1.
Weldnut cleaning – use a M12x1.25 tap to clean (2) weldnuts at the end of frame rail each side if necessary, see Figure 2.
2.
Hitch installation – insert pull wires ⑤ into bumper beam through bumper beam side opening and then use them to feed carriage bolts ③ and spacer ④ into bumper beam, see Figure 3, 4. Leave pull
wires attached. Raise the hitch into position and feed carriage bolts through top plate holes, see Figure 1. Loosely install M12 bolts ① and conical washers ② through bracket holes into frame weldnuts.
Loosely install nut ⑦ and conical washer ⑥ on carriage bolts.
3.
Tighten all M12 fasteners with torque wrench to 105 Lb.-Ft. (142 N*M) and all 7/16'' fasteners to 50 Lb.-Ft. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or ball which has been
damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 75238, 84238
③
④
Bumper
beam
Rear
⑥
⑦
Figure 1
①
②
③
④
⑤
⑥
⑦
Figure 2
Frame
weldnut
②
①
Sheet 3 of 12
75238NP
Fastener Kit: 75238F
Qty. (4)
Bolt M12
1.25x40 , CL10.9
Qty. (4)
Conical washer
1/2''
Qty. (2)
Carriage bolt
7/16''-14x1.25, GR5
Qty. (2)
Spacer
.109 with SQ. hole
Qty. (2)
Pull wire
7/16''
Qty. (2)
Conical washer
7/16''
Qty. (2)
Hex nut
7/16'' -14 GR2
Frame rail
Figure 4
⑤
2-23-16
Rev. B
Publicidad
Tabla de contenido
