Cequent Performance Products 75280 Instrucciones De Instalación

Bumper Structure
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75280F
Wrenches: 10mm, 17mm, 19mm
Drill Bits: None
j
Qty. (6) Hex Bolt M12 x 1.25 x 35mm CL8.8
k
Conical Toothed Washer ½"
Qty. (6)
1. Lower the exhaust and remove the muffler heat shield.
2. Raise the hitch into position as shown.
3. Install the six (6) M12 fasteners into the frame rails and the two (2) M10 fasteners into the bumper structure as shown.
4. Re-install the heat shield and the exhaust.
Tighten all M10 CL8.8 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Tighten all M12 CL8.8 fasteners with torque wrench to 76 Lb.-Ft. (103 N.*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle
and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2005, 2007, 2009, 2011 Cequent Performance Products
Installation Instructions
ml
kj
Honda Ridgeline
Fascia
Hitch type
Weight Distributing
Weight Carrying
Ball Mount
Wiring Access Location: PU1, PU2
l
Qty. (2)
m
Qty. (2)
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Max Gross
Trailer WT (LB)
7500 (3405 Kg.)
5000 (2270 Kg.)
Existing Weldnuts
jk
Hex Bolt M10 x 1.25 x 30mm CL8.8
Conical Toothed Washer 7/16"
75280N 08-08-11
Part Numbers:
75280
44528
70754
Max Tongue
WT (LB)
750 (341 Kg.)
750 (341 Kg.)
Rev. D
Form: F205 Rev A 5-6-05