Cequent Performance Products 36524 Instrucciones De Instalación

Frame rail
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 36524F
Wrenches: 11/16"
Lift gate sensor reduced to this
area on vehicles with the "Hand
free lift gate" option.
Figure 2
File
INSTRUCTIONS:
1 . Check to see if spacer and bolt head will fit through access hole, if not
modify hole to accept hardware, the illustration above shows two ways of
achieving this, the first is using a file, the second is by inserting a wrench or
prying as shown. Enlarge hole just enough to get hardware through.
1 1 1 1
Qty. (4) Carriage bolt 7/16-14 X 1.50 GR5
2 2 2 2
Qty. (4) Spacer ¼ X 7/8 X 3.00
3 3 3 3
Qty. (4) Conical washer 7/16
Note: With the hitch installed on vehicle with "Hands free lift gate" options it will only work in limited area.
See Figure 2.
1. Feed spacers and carriage bolts into position using the pull wires provided (both rail). Leave pull wire attached. Note: It is much
easier if bolt and spacer are not engaged while inserting them into frame, refer to illustration. See Figure 3.
2. Push (only) fasteners back into frame rail leaving pull wire and the extra wire sticking out of the frame rail.
3. Raise hitch into position between frame rails, feed pull wires thru adjacent holes in the hitch. On the passenger side raise the
forward end of the bracket over the hoses crossing the frame rail (not shown).
4. Pull fastener back through access holes and hitch.
5. Remove pull wires and attach conical washers and nut (be careful not to push fastener back into frame rail).
6. Tighten to specification.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
© 2014, 2015 Cequent Performance Products, Inc – Printed in México
Installation Instructions
Fascia
Drawbar must be used in the
Rise position only.
Tail pipe
Access hole
Wrench
Tighten all 7/16-14 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Ford Escape
(Sold separately)
Drawbar Kit:
36071
Do Not Exceed Lower of Towing Vehicle
3500 LB (1589 Kg) Max Gross Trailer Weight
300 LB (136 Kg) Max Tongue Weight
Frame rail
Figure 1
Vehicle forward
4 4 4 4
Qty. (4) Hex nut 7/16-14 GR2
5 5 5 5
Qty. (4) Pull wire 7/16
Sheet 1 of 3
Part Numbers:
Manufacturer's Rating or
Wiring Access Location: SUV 1 & 2
1 1 1 1
2 2 2 2
Kink pull wire to keep
spacer independent of bolt
Figure 3
Access hole
Note: Fasteners typical both sides
36524N 10-9-15
Form: F205 Rev A 5-6-05
36524
90219
06147
5 5 5 5
3 3 3 3 4 4 4 4
Rev. D