Cequent Performance Products 24930 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Frame Rail
Teeth side
against hitch
Figure 3
Note: Fasteners typical
both sides
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequent
group.com/qr-
product.aspx
1. Feed the coiled end of the pull wire through rearward hole and out the access hole. Attach spacer and carriage bolt onto pull wire and feed the fasteners into location through the
hole. Leave pull wires attached. Repeat the same process on the both frame rails. Note: it may be easier to install the carriage bolt head first. Repeat with the forward holes. Both
frame rails.
2. Raise the hitch over the exhaust pipes into position, feed the pull wires through the slots of the hitch brackets.
3. Feed conical washer over pull wire, using the washer to hold the bolt in place remove the pull wires and attach the hex nut. Tighten to hold hitch in place, repeat with all fasteners.
4. Center hitch on the vehicle.
5. Tighten all 7/16-14 GR5 fasteners with torque wrench to 50 Lb.-Ft. (68 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 24930, 60368, 77317
Drawbar must be used in the
⑤
2''
3''
Rear
Figure 1
Printed in Mexico
(Sold separately)
Drawbar Kit:
3594
RISE position only.
Fastener Kit: 24930F
①
②
③
④
Sheet 3 of 12
① Q t y . ( 4 ) Carriage bolt
7/16-14 x 1.50 GR5
② Qty. (4) Spacer
3/16 x 1 x 2
③ Qty. (4) Conical washer
7/16"
④ Qty. (4) Het Nut
7/16-14
⑤ Qty. (4) Pull wire
7/16
Access
Hole
Kink Pull wire to
keep spacer
independent of bolt
Example of pull wire procedure
Figure 2
24930NP 9-29-15
⑤
Rev. B