Publicidad
Idiomas disponibles
Idiomas disponibles
Note: Most installations will not require you to change any jumpers on
your chime and pushbutton.
WARNING: Disconnect chime unit from power source before opening
code access door. Close door and replace screw before reconnecting
to power.
The pushbutton and chime communicate by using a code that can be changed
by removing and/or adding jumpers on both the pushbutton and chime. The
code is factory set; however, there are 128 selectable codes that allow you
to expand your system and prevent outside interference. Other wireless prod-
ucts may cause interference and the system may not function properly. Fol-
low the instructions below for setting a new code.
1. Unplug wireless chime.
2. Open the cases and locate the jumpers on both the pushbutton and chime
(See illustration on page 3).
3. The pushbutton and chime both have eight different jumper locations. The
jumper positions 1 through 7 are used for setting the code.
4. To change the code, add and/or remove jumpers as needed. It is recom-
mended to only change one jumper at a time and then check to see if
system is functioning properly. Note: Jumpers in positions 1 through 7
must be exactly the same for both the pushbutton and chime for this sys-
tem to function.
Use either screws or double sided tape to mount
pushbutton.
To mount with screws, remove back of case by pushing
in tab on bottom with a small screwdriver.
Attach back of case to door jamb or wall. Snap front of
pushbutton on.
When attaching pushbutton using double sided tape,
make sure the surface of the door jamb or wall is clean.
Code and Tune Settings
Code Settings
4.
Mount pushbutton.
-2-
595-5684-06
Publicidad
