Descargar Imprimir esta página

Desa Heath Zenith SL-6151 Manual Del Usuario página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

Chime doesn't sound:
• Make sure pushbutton and chime codes are the same (See pages 2 and 3).
• Check orientation of pushbutton battery (See page 3).
• Check pushbutton battery charge, replace if necessary.
Batteries seem OK, but the chime doesn't work when installed:
• Don't mount chime or pushbutton on metal or near metal studs. This re-
duces the transmitter range. Use 1/4" to 1/2" (6 to 13 mm) wood shims to
move chime or pushbutton off metal surface.
• Concrete floors may reduce range. Move chime away from floor.
• Try locating chime closer to pushbutton.
The range of the wireless chime can vary with location, temperature and
battery condition.
This device (SL-6151-RX-A, WB-94A-TX) complies with Part 15 of the FCC
Rules and RSS-210 of Industry Canada. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that
may cause undesired operation.
The user is cautioned that changes or modifications not expressly approved
by the party responsible for regulatory compliance could void the user's au-
thority to operate the equipment.
Do not send products, please call the number listed below:
Technical Service: USA call 1-800-858-8501/Canada call 905-826-8010
or visit our website: www.desatech.com.
DESA International, Inc.
P.O. Box 90004, Bowling Green, KY 42102-9004
Troubleshooting
Regulatory Information
-4-
595-5684-06

Publicidad

loading