EAS ELECTRIC NT-03A Manual De Instrucciones página 8

1.1 Instructions of remote controller
"HVAC No.2" remote controller (compatibility with wire controller or lamp board): extension code,
applicable to most VRV models.
"HVAC No.3" remote controller (compatibility with wire controller or lamp board): general code,
applicable to all models (except of Window machine).
！
Warning
！
Do not place remote controller near heat sources such as electric blankets or heating furnaces.

Do not place remote controller in direct sunlight.

Be careful not to drop, otherwise it may cause damage.

No obstacle between the signal receiver and the remote controller, so as not to affect the

transmission and reception of the signal.
Do not splash water or other liquids onto the remote controller.

Temperature addition
Increase the setting temperature.
Temperature reduction
Decrease the setting temperature.
"ON/OFF"
Open or close the air-conditioner.
Fan speed -
Reduce fan speed in one gear.
Minimum wind speed will switch to
the automatic wind, and switch to
the highest wind when pressing
Timer
Setting timing ON/OFF.
Clock
Modify the current time of the
remote controller.
Lock
Lock the remote controller buttons.
！
Warning
！
Point the remote controller to the air conditioner, press the button on the remote controller, and

send the command signal to the air conditioner.
If the signal is received correctly, the air conditioner will issue a "beep" prompt.

If the remote controller is not available, please replace the new battery and try again. But if the

problem persists, please contact the seller or our authorized service center.
7
Mode
Select modes, including automatic,
cooling, dehumidification, fan and
heating mode.
Fan speed +
Increase fan speed in one gear.
Highest wind speed will switch to
the automatic wind, and switch to
the minimum wind when pressing
i
Turbo
Enter the turbo function. Decide
whether to have this function
according to the actual model.
ECON
Automatically setting 26 in
℃
cooling or heating mode.
Sleep
Enter the sleep function. Decide
whether to have this function
according to the actual model.
Light
Forced closing or lighting of display
panel. Decide whether to have this
function according to the actual
model.
Up and down swinging
Open the external pendulum wind.
Left and right swinging
Open the internal pendulum wind.
V.1