Freezer Features and Use
Operating Your Freezer
• Set the temperature, on the temperature control knob. "1" being the
warmest and "7" being the coldest. Initially set the temperature on
"4". Place food inside the freezer. After using the freezer for 24 hours
set the freezer to your desired setting.
• In case you unplug your freezer or experience an electrical outage,
allow 5 minutes before plugging it back in.
General Features
Adjustable temperature dial:
Thermostat Instructions
This storage temperature is controlled by the electronic thermostat. According to different
environmental temperature, different kinds and quantities of storage things ,
The temperature of the inner cabinet can be adjusted by the thermostat button within proper
range.
Under normal condition, when press the Refrigerating temperature setting button, the digital
tube will flash to display the corresponding setting temperature, and the refrigerating indicator
lamp will become bright. Each time setting, the refrigeration value is reduced by 1, until the
minimum value, then it will change to the maximum value. No buttons for 5 seconds, or press for
3 seconds, it will save the setting temperature and return to normal situation.
Freezing temperature setting:
Under normal condition, when press the freezing temperature setting button, the digital
tube will flash to display the corresponding setting temperature, and the freezing indicator lamp
will become bright. Each time setting, the setting value is reduced by 1, until the minimum value ,
then it will change to the maximum value. and the jump is reached to the maximum value. No
buttons for 5 seconds, or press for 3 seconds, it will save the setting temperature and return to
normal situation.
Button Locked setting:
Under normal condition, continuously press the freezing temperature setting button for 3
seconds, indicating lamp which was not bright will flash, or no button operation after 30 seconds,
it enters the button locked mode ;Under button locked mode, continuously press the freezing
temperature setting button for 3 seconds, the flash light go out and return to normal mode.
(Note: As the product is constantly updated, please refer to the actual one.)
(see fig. # 1)