NETGEAR Powerline 1000 Inicio Rápido página 9

Note: The Security button does not work in power saving
mode (see
Warning: Do not press the Security button until installation is
complete and the adapters are communicating with each other
(indicated by the blinking Power LED). Pressing this button too
soon can temporarily disable Powerline communication. If this
occurs, use the Factory Reset button to return the Powerline
adapter to its factory default settings.
Customize Your Network Security
When you first set up your network, the setup uses a default
encryption key common to all adapters. You can change this.
¾ To create a private secure network:
1. Wait until the Pick A Plug LEDs are lit.
2. Press the Security button for two seconds on one adapter.
Note: The Security button does not work in power saving
mode (see
3. Within two minutes, press the Security button on the next
adapter for two seconds.
Troubleshooting Tips
Troubleshooting Tips
on page 10).
on page 10).
9