Publicidad
Idiomas disponibles
Idiomas disponibles
Assembly and Instructions for Use
1. Unpack the product.
2. Familiarize yourself with the pump. The switch located at the front of the pump controls the
pump speed. The speed is indicated by a plus (+) and minus (-) sign. To increase the speed,
move the switch slowly downward in the direction of the plus sign. You will hear a click as the
switch moves to each speed level. At its highest speed level, the switch will cease to move
any further. To decrease the pump speed, move the switch upward toward the minus sign.
Similarly, at its lowest speed, the switch will cease to move any further (Fig 1).
NOTE: It is recommended the pump be set at its highest speed during assembly and later
adjusted to a lower setting if desired. Be sure to unplug the pump before adjusting the speed
setting.
3. Insert the tube into the pump. (Fig. 2)
4. Fill base with clean water. (Fig. 3)
5. Attach the A/C adaptor jack to the base power cord. DO NOT plug into outlet at this time.
(Fig. 3)
6. Set the fountain on a level, waterproof surface.
7. Plug the cord into 120V household outlet. The switch located on the power cord controls the
fountain. If pump doesn't operate, rotate in-line switch once to turn "on" and once more to
turn "off". Monthly maintenance will add to your pump's life.
NOTE: Ensure that the electrical cord loops below the electrical outlet to form a 'Drip Loop'
(Fig. 4). This will prevent water from running down the cord into the electrical outlet.
Figure 1
Minimum Water Level
Flow Control Valve
(+) faster water
output
(-) slower water
output
4
Figure 2
Attention:
In order to get
best results,
please operate
pump completely
submerged.
Keep the water
level above the
minimum water
level ALL THE
TIME.
Figure 3
Figure 4
Drip Loop
5
Publicidad
