Technical Data; System Requirements - AVM FRITZ!WLAN Repeater 310 Manual Del Usuario

FRITZ!WLAN Repeater 310 in the Home Network
On a Wireless Access Point from Another Manufacturer
• For registration with a wireless access point via WPS, the FRITZ!WLAN Repeater 310 adopts the SSID
(radio network name) and network key of the wireless access point.
Updates are performed directly in the user interface of your FRITZ!WLAN Repeater 310 under System/
•
Update.
The FRITZ!WLAN Repeater 310 user interface can be opened on all connected devices using the IP
address it was assigned by your wireless access point.
First check the user interface of your wireless access point to fi nd out what IP address the FRITZ!WLAN
Repeater 310 was assigned, and then enter this IP address in the address line of a web browser.
See the documentation for your wireless access point.
10

Technical Data

• IEEE 802.11n, compatible with IEEE 802.11b/g
• Up to 300 Mbit/s (gross); the user data rate
that can actually be achieved is somewhat
below the specifi ed values.
• WEP 64/128, WPA, WPA2 (802.11i)
• Total power consumption: approx. 3 W
• Wireless LAN: 2.4 GHz max. 100 mW
• 230 V, 50 Hz A/C
• 0 °C to +40 °C
• Dimensions: 81 mm x 51.5 mm x 66.5 mm
• Weight: approx. 63 g
• Two integrated antennas

System Requirements

• 2.4 GHz wireless access point compliant with
IEEE 802.11b/g/n, automatic IP address
assignment (DHCP)
• The wireless access point must support the
encryption standard WPA or WPA2.
• For expanded Mesh WiFi functions: FRITZ!Box
with FRITZ!OS version 6.90 or higher
• Automatic IP address assignment (DHCP)
• For initial confi guration with WPS: WPS-compli-
ant wireless access point
• For initial confi guration without WPS: computer
with wireless LAN that supports the WPA
encryption standard
• For the fi rst confi guration of WLAN: If the MAC
address fi lter is active in the wireless access
point, the MAC address of the FRITZ!WLAN Re-
peater must be entered as an exception in the
11
MAC address fi lter