Technical Data - Beninca IRI.KPAD.C Manual Del Usuario

1.2) TECHNICAL DATA

Power supply
Absorption (Stand-alone mode)
Working temperature
Number of codes saved
Level of protection
Dimensions
1.3) WALL MOUNTED INSTALLATION (FIG. 2)
IRI.KPAD.C can be applied to the wall using the screws and plugs indicated in Fig.7.
1) Use a screwdriver to open the prepared cable passage section on the wall support (Fig.2)
2) Remove the cover protecting the terminal board and open the prepared cable passage section with a screwdriver (Fig.3/4).
ATTENTION! Make a same sized hole as the cable to avoid water infiltration. If necessary, seal with silicone.
3) Apply the adhesive gasket on the back of the wall support.
Note: The central part of the keypad can be removed to leave the part beneath in view. In this case, remove the central part of
the gasket and apply it to the support having removed the central cover (Fig.5).
Alternatively, leave the closure cover in position and apply the entire adhesive gasket Fig. 6.
4) Fasten the support to the wall (Fig.7), with screws and plugs according to the type of support.
5) Pass the connection cables through the openings (Fig.8)
6) Install the connections with reference to the "Electrical connections" paragraph.
7) Rest the IRI.KPAD.C on the support and fasten it with the screw (Fig.9).
The level of protection IP54 also enables outdoor use. However, application is preferred to a protected wall.
IRI.KPAD.C can only be installed on vertical walls, respecting the instructions in the previous points. Outdoor installation is not
permitted on horizontal or tilted supports (Fig.9).
12/24 Vac/Vdc in stand-alone mode
10 mA
-20°C / +70°C
30 STAND-ALONE MODE codes
254 REMOTE MODE codes
IP54
see Fig.1
17