Matco Tools AL24 Instrucciones De Operación página 2

fAiLure To oBserVe These WArnings couLd resuLT in inJury
This insTrucTion
iMporTAnT sAfeTy inforMATion.
reAd This insTrucTion MAnuAL cArefuLLy
And undersTAnd ALL inforMATion Before
operATing This TooL.
• Always operate, inspect and maintain this tool in
accordance with American National Standards Institute
Safety Code of Portable Air Tools (ANSI B186.1) and any
other applicable safety codes and regulations.
• For safety, top performance and maximum durability of
parts, operate this tool at 90 psig; 6.2 bar max air
pressure with 3/8" diameter air supply hose.
• Always wear impact-resistant eye and face protection
when operating or performing maintenance on this tool.
• Always wear hearing protection when using this tool.
High sound levels can cause permanent hearing loss.
Use hearing protection as recommended by your
employer or OSHA regulation.
• Keep the tool in efficient operating condition.
• Operators and maintenance personnel must be
physically able to handle the bulk, weight and power of
this tool.
• Air powered tools can vibrate in use. Vibration, repetitive
motions or uncomfortable positions over extended
periods of time may be harmful to your hands and arms.
Discontinue use of tool if discomfort, tingling feeling or
pain occurs. Seek medical advice before resuming use.
• Air under pressure can cause severe injury. Never direct
air at yourself or others. Always turn off the air supply,
drain hose of air pressure and detach tool from air supply
before installing, removing or adjusting any accessory
on this tool, or before performing any maintenance on
this tool. Failure to do so could result in injury. Whip
hoses can cause serious injury. Always check for
damaged, frayed or loose hoses and fittings, and replace
immediately. Do not use quick detach couplings at tool.
See instructions for correct set-up.
• Slipping, tripping and/or falling while operating air
tools can be a major cause of serious injury or
death. Be aware of excess hose left on the walking
or work surface.
descripTion
This Filter/Regulator/Lubricator is a 3 part system. The filter is
designed to remove most liquid and solid particles from the air
supply. The self-relieving pressure regulator is used to adjust the
outlet pressure between 0-140 PSI. The lubricator provides oil to
the air tool and increases the life of the tool.
AL24
AL24 FILTER, LUBRICATOR AND REGULATOR UNIT
MAnuAL conTAins
WARNING
• Keep body working stance balanced and firm. Do
not overreach when operating the tool.
• Anticipate and be alert for sudden changes in motion
during start up and operation of any power tool.
• Do not carry tool by the hose. Protect the hose from
sharp objects and heat.
• Tool shaft may continue to rotate briefly after throttle is
released. Avoid direct contact with accessories
during and after use. Gloves will reduce the risk of cuts
or burns.
• Do not lubricate tools with flammable or volatile liquids
such as kerosene, diesel or jet fuel.
• Do not force tool beyond its rated capacity.
• Do not remove any labels. Replace damaged labels.
• Pressure systems can leak causing flying particles.
• Wear safety goggles (User and bystanders).
• Read and follow instructions.
• Flying particles can cause injury.
• Compressor systems contain air under pressure.
• Relieve pressure before servicing.
• A pressurized air stream can cause injury.
• Air from in line Lubricators may contain oil or other
harmful material.
• Use in well ventilated area.
• Oil and other impurities in breathing supply air can
cause injury.
• WARNING: Handling the brass parts of this
product will expose you to lead, a chemical known
to the State of California to cause birth defects and
other reproductive harm. Wash hands after handling.
2 05/15/12