PROFLO PFCF208 Instrucciones De Instalación

Installation Instructions
Two Handle Faucet
PFCF208
Fig. 1 Faucet Installation
1.For replacement applications, ensure that the
water supply is turned completely off at the supply
valve before attempting removal and replacement
of the existing faucet.
2.For replacement applications, ensure the sink
deck is clear of any surface dirt or debris before
setting the new faucet in place.
3.Using the included brass locknuts (No. 9) and
metal washers (No.8), secure the faucet to the
deck, making sure that the faucet draws down
tightly to prevent any movement or shifting.
4.Connect the hot and cold water supply
connectors to the appropriate inlet. If you
are using coned supply risers, use the brass
coupling nuts (No. 10) included with
the faucet kit. For installations employing
other types of supply connectors, consult the
manufacturer's installation instructions.
5.To install the spout, insert the spout assembly
into the receiver of the spout canopy (No. 12.)
© 2008 Wolseley Distributed exclusively by Wolseley's North American Division, Ferguson, Stock Building Supply and Wolseley Canada.
Two Handle Faucet Assembly
No. Part Title Material
1 Set Screw Brass
2 Red Washer Plastic
3 Blue Washer Plastic
4 Handle Zinc
5 Brass Ring Brass
6 Cartridge Brass, Ceramic
7 Cartridge Brass, Ceramic
8 Body Brass
9 Escutcheon PU
10 Lock Washer Steel
11 Lock Nut Brass
12 Cone Washer NBR
13 Coupling Nut Brass
14 O-Ring NBR
15 Spout Screw Brass
16 O-Ring NBR
17 Clip PP
18 "C" clip POM
19 Spout Nut Brass
20 Spout Brass
21 Washer Silicon
22 Spout Head Brass
23 Washer NBR
24 Filter POM
25 Areator Brass
6.Thread the spout nut onto the spout canopy
and tighten using an appropriately sized wrench.
Qty
Hint... To prevent damage to the finish slip a
2
piece of heavy cloth between the wrench faces.
1
7.Turn the water on and check for leaks. To
1
correct for leaks at a supply connection , gently
1
tighten the faucet coupling nut until the leak stops.
1
8.Turn the faucet on and check for adequate flow
2
rate. If flow rate is low , remove
2
aerator, flush and reassemble.
1
1
1
1
2
2
2
1
2
1
1
2
1
1
1
1
1
1
1173 04/08