Fanaway LD-48 FAN IN Manual Del Usuario página 4

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Fanaway Industri Installation Instructions
with the wiring rules.
Example: If a fan is connected to a circuit that can be isolated via an
all-pole safety switch at the switchboard, then this is considered to be
an all-pole disconnection to the ceiling fan electrical circuit, meeting the
requirements of clause 7.12.2 of AS/NZS 60335.1.
A single-pole switch on the active of the receiver input of remote
control must also be included in the wiring, and located the same
room as the ceiling fan.
Do not dispose of electrical appliances as unsorted municipal waste, use separate collection facilities.
5.
Contact your local government for information regarding the collection systems available. If electrical
appliances are disposed of in landfills or dumps, hazardous substances can leak into the ground water
and get into the food chain, damaging your health and well-being.
The structure to which the fan is to be mounted must be capable of supporting a weight of 50kg.
6.
The fan should be mounted so that the blades are at least 2.3 m above the floor in Europe or 2.1 m above
7.
the floor in Australia.
This fan is suitable for indoor use only. Mounting the fan in a location where it is subject to water or
8.
moisture is dangerous and may increase the risk of damage, injury or electrical shock and will void the
warranty.
Must be assembled and installed by a licensed electrician.
9.
10. WARNING: If unusual wobbling or oscillating movement is observed, immediately stop using the ceiling
fan and contact the manufacturer, its service agent or suitably qualified persons.
11. The replacement of parts of the safety suspension system device shall be performed by the manufacturer,
its service agent or suitably qualified persons.
12. The fixing means for attachment to the ceiling such as hooks or other devices shall be fixed with a
sufficient strength to withstand 4 times the weight of the ceiling fan; that the mounting of the suspension
system shall be performed by the manufacturer, its service agent or suitably qualified persons.
4 | P a g e
V1.1 EU (11/2019)

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

212920212921

Tabla de contenido