SUOMY apex Manual Del Usuario página 26

ENG
USER'S INSTRUCTIONS
BACK AIR DEFLECTOR
Removal
The back deflector is fixed to the shell through two-way adhesive tape, to remove it just lift (X) one side and pull upwards firmly. If it is difficult
to remove, use a tool (for ex. a screwdriver) and lever on the shell. During this operation protect the point of contact of the tool with the shell
with a cloth to avoid damaging or scratching the paint. Do not put the tool in-between the edge of the back deflector and the shell.
We suggest levering using your hands as shown in the illustration.
After removing, before replacing the parts, remove any adhesive (A) or dirt residues (A) from the shell.
Fitting the deflector
The back deflector is fixed to the shell through two-way adhesive tape, the application surfaces must be perfectly clean (not greasy) and dry
to assure effective and reliable gluing.
Before applying, carefully clean the surfaces where the device has to be applied to.
Verify the positioning of the details by applying them on the shell in the correct position, before removing the two-way adhesive protection liner.
The back deflector must be positioned in the proper seat on the back part of the shell. Verify that the side and upper edges of the deflector adhere
to the ribbing on the shell. (see fig. 4B). Remove the protection liner (A).
Position the part on the shell in the correct position, by pressing evenly on the edges; perform this operation from the front part (W) to the back
part (J) and never vice versa. During application avoid touching the adhesive tape with your fingers. The removal and following repositioning
of the component reduces the effectiveness of the adhesive. Adhesion is immediately effective; the maximum performances of the tape
are reached after 24 hours from application. Do not use helmet during this period.
X
24
see figure 4A
see figure 4B
A
A
figure 4A
W
A
A
W
see figure 4A and 4B
J
J
figure 4B