SUOMY apex Manual Del Usuario página 27

ENG
USER'S INSTRUCTIONS
PADDING
The inner padding can be easily removed to be washed or replaced.
Inner central padding: SMALL SHELL – Removal and Fitting see figure 5
The inner shell (A) is fixed to the helmet through 4 press studs (B).
B
B
Removal
Snap open the press studs (B) and remove the inner shell (A). Be very careful when removing the
shell, press on the rigid part of the stud and pull slightly towards the inside of the helmet without
A
damaging the press stud.
B
B
Caution: to avoid damaging the inner lining, before removing the inner shell make sure all
the press studs have been snapped open.
Fitting the shell
Insert the shell (A) inside the helmet checking the assembly direction. Fasten the press studs (B).
figure 5
After fixing the shell and cover make sure the shell is correctly positioned inside the helmet
(polystyrene padding).
X
Inner side padding: CHEEK PADS – Assembly and disassembly
Y
The cheek pads are fixed to the inner lining of the helmet through a mechanism applied to the chin
guard that can be enabled without using tools (SUOMY patent).
A
Removal see figure 6
Push (X) the lever (A) to the back of the helmet until it is released from the lock position.
Lift the lever (A) making it rotate (Y) towards the inside of the helmet until it is completely
tilted up.
Grab the cheek pad in the front, push it towards the back of the helmet and at the same time
rotate it towards the inside until it is completely out of the chin guard. Pull the cheek pad towards
the front of the helmet until the fastening tab is out. Slide out the strap from the hole inside the
cheek pad.
figure 6
25