REPLACING EVAPORATIVE WICKS
8)
Remove both bottles.
9)
Depress both latches to remove grille and wicks.
10)
Replace wicks and grille, latches will snap in place
11)
Replace bottles to original position (See Figure B).
NOTE: Overfilling will result in water damage.
OPERATION
DESIRED
HUMIDITY
SETTING
LOW - 1 DROP
THROUGH
HIGH- 4 DROPS
ACTUAL
HUMIDITY
READING
HUMIDITY
CONTROL
BUTTON
1)
Plug cord into wall receptacle. Your humidifier is now ready for use. The
humidifier should be placed at least FOUR inches away from any walls and
away from heat registers. Unrestricted airflow into the unit will result in the best
efficiency and performance.
2)
The digital control allows you to use the low setting for the quietest operation or
a high setting for maximum output.
3)
For initial operation, push the speed button once for the sleep setting and
continuously press the button to increase desired speed to the highest speed.
TO STOP the unit, press the button for two seconds, or keep pressing button
until display reads OFF.
4)
To take advantage of the digital humidistat, press the speed button to any
setting other than OFF. Then adjust the set humidity by using the up and down
buttons. Humidity will increase in increments of 10%. When the room humidity
level rises above the set humidity, the humidifier will stop. When the humidity
level drops below the set humidity, the humidifier will turn on automatically.
5)
The refill light will indicate when the unit is completely out of water in both
bottles. The motor will also shut off. To refill, refer to Step 4 IMPORTANT
FILLING INFORMATION.
NOTE: When excessive condensation exists, a lower speed setting is
recommended.
CAUTION: Disconnect power before filling, cleaning or servicing unit. Keep
grille dry at all times.
%
%
HUMIDITY
SPEED
PRESS TO SET
PRESS TO SET
RANGE 25% - 65%
HOLD FOR OFF
4
FAN SPEED
INDICATOR
LOW - 1
THROUGH
HIGH - 4
REFILL INDICATOR
POWER INDICATOR
FAN SPEED
BUTTON