ration. In the event of any malfunction, consult the next
paragraph"Troubleshooting".
ELECTRICAL APPLIANCES
Switch on the appliance as directed in the instructions and re-
minders for use given in Chapter " INSTRUCTIONS FOR USE
" and check:
• the current values of each phase.
• the correct operation of the heating elements.
15 TROUBLESHOOTING
ELECTRIC FRYERS
The appliance does not heat.
Possible causes:
• Temperature thermostat defective.
• Heating elements defective.
• Safety thermostat tripped.
Heating cannot be adjusted.
Possible causes:
• Temperature thermostat defective.
16 REPLACING COMPONENTS
REMINDERS FOR REPLACING COMPONENTS.
• Disconnect the appliance electrical power supply, if present,
before proceeding with any operation.
• After replacing a gas system component, check for gas leaks
at connection points.
• After replacing an electrical system component, check it is
correctly wired.
ELECTRIC FRYERS
Replacing the working thermostat and safety thermostat.
• Drain off all the oil from the well
• Unscrew the locking nut on the heating element flange.
• Release the thermostat bulb to be replaced; it is secured
between the heating elements with a flexible clip.
• Disconnect the electrical connections to other devices.
• Remove and replace the component.
• Change the sensor/bulb sealing O-ring in the well.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
Replacing the heating element
• Drain off all the oil from the well
• Remove the control panel.
• Release the thermostat bulbs secured between the heating
elements.
• Disconnect the electrical connections to other devices.
• Remove and replace the component.
• Re-assemble all parts. For assembly, proceed in reverse or-
der.
17 CLEANING THE INTERIOR
• Check the condition of the inside of the appliance.
• Remove any built-up dirt.
• Check and clean the fumes exhaust system.
8
18 MAIN COMPONENTS
ELECTRIC FRYERS
• Safety thermostat
• Working thermostat
• Heating element