Installation And Lubrication - Ingersoll Rand 2934 Serie Manual De Instrucciones

EN
Models
2934A2
2934B2, 2934B2-EU, 2934B2SP-EU
2934B9, 2934B9-EU
2934P2, 2934P2-EU
2940A1
2940A2
2940B1
2940B2, 2940B2SP-EU
2940P2
2945A1
2945A7
2945B1
2945B7
2950A7
2950B7, 2950B7-EU
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
*K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 47132600 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size
Parts and Maintenance
When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
Sound Level dB(A)
(ISO15744)
† Pressure (L ) ‡ Power (L
p
94.9
94.9
93.2
89.4
94.8
94.8
94.8
94.8
94.2
93.3
93.3
93.3
93.3
94.4
94.4
WARNING
7. Coupling
8. Safety Air Fuse
9. Oil
10. Grease - during assembly
11. Grease - through fitting
Vibration (m/s²)
(ISO28927)
) Level
w
105.9 18.8
105.9 18.8
104.2 30.8
100.4 18.3
105.8 17.8
105.8 17.8
105.8 17.8
105.8 17.8
105.2 18.1
104.3 18.1
104.3 18.1
104.3 18.1
104.3 18.1
105.4 18.1
105.4 18.1
04584835_ed6
*K
3.7
3.7
10.2
5.3
3.4
3.4
3.4
3.4
5.6
5.6
5.6
5.6
5.6
5.6
5.6