Bluetooth Mode; Product Specification - THOMSON DS120ICD Instrucciones De Funcionamiento

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20

Bluetooth Mode

BT function
1. Press the SOURCE button to select BT mode. The LED shows "BT''.
2. Turn on BT functionality on your BT device. Typically, BT controls are found on the device's tools
or settings menu (see your user manual).
3. Turn on BT connectivity and make your device 'discoverable".
4. Choose 'add a new BT device' or 'setup BT device' on your device. It will start to search. Once
"DS120ICD" shows on your device, select it. If your device prompts you for a pass code, please
enter 0000. If the pairing attempt fails or times out, please start the pairing procedure again (see
steps above).
5. After your device and the "DS120ICD" have connected to each other, a sound can be heard.
6. Make sure the BT connection between the unit and the device is active.
7. Press the
button to pause playback. Press again to resume playback and press
skip forward to next track and
Remark: The maximum connection distance is around 10 meters. Please place your Bluetooth
speaker as close as possible to this device to avoid the connection being disturbed.

Product specification

Power supply: 230V~50Hz
Max consumption: 20W
Input sensitivity: LINE IN 775MV
Speaker impedance: 4 ohm
S/N (A): 86db
THD (1kHz,1W): 0.5%
Frequency response: 100Hz-20 KHz
Bluetooth frequency band: 2402-2480MHz
FM frequency: 88.8-108.00MHz
Total music output: 5W X2
ABOUT THE DISKS
to skip backward to the previous track.
Handling
Do not touch the underside of disks.
Hold disks by the edges to avoid leaving fingerprints on the surface.
Any dust, fingerprints or scratches may cause a malfunction.
Never affix a label or sticky tape to the disk.
Storage
Put disks back in their case after use.
Never expose disks to direct sunlight or heat sources. Never leave disks
inside a car parked in full sunlight.
Cleaning
Use a clean, soft, lint-free cloth to clean the disk, working from the centre
outwards in a straight line. Do not use solvents such as petrol, thinners,
commercially available cleaners or antistatic sprays for vinyl disks.
- EN 7 -
button to

Publicidad

Tabla de contenido
loading

Tabla de contenido