User Maintenance Instructions; Troubleshooting Guide; Tool Specifications - Porter Cable PXCM024-0271 Manual De Instrucciones

Air Motor Lubrication
To maintain the maximum performance of the air tool, it must be lubricated each time it is used. Dust, dirt,
rust and oil residue will build up inside the tool and reduce the performance. An in-line oiler is recommended for
proper automatic tool lubrication (see Figure A). If an in-line oiler is not available, the tool can be lubricated manu-
ally through the inlet port (see Figure D).
1. Disconnect the air tool from the air supply.
2. Turn the tool upside down and while depressing the trigger, add 4-6
drops of air tool oil or SAE10 nondetergent oil into the air inlet.
NOTE: Depressing the trigger helps circulate the oil in the air motor.
3. Reconnect the tool to the air supply, cover the exhaust port end with a
towel and run in forward and reverse directions for approximately 30
seconds to remove excess oil.
NOTE: If the tool remains sluggish after it has been lubricated, the
internal components may need to be cleaned.
To Clean:
Disconnect the air tool from the air supply and pour or spray a gener-
ous amount of WD-40® into the air inlet with the trigger depressed. Connect
the tool to the air supply, cover the exhaust port end with a towel and run in
forward and reverse directions for approximately 30 seconds. Follow the air motor lubrication instructions above
after cleaning is completed to re-lubricate the tool.
After oiling or cleaning, cover the exhaust port with a towel and operate the tool for a
few seconds to safely remove the excess oil. Clean the handle and surface of the tool of any oil residue.
Failure to cover the exhaust port and clean the tool can result in serious injury. Note: Keep the towel
away from moving parts!
SYMPTOM
Tool will not run or runs
slowly
Excessive vibration
Maximum RPM
Average SCFM Requirements
Air Inlet
Maximum Cut-off Disk Diameter
Recommended Hose Size
Maximum Working Pressure
FREE WARNING LABEL REPLACEMENT: If your warning labels become illegible or are missing, call 1-(888)-
895-4549 for a free replacement.
USER-MAINTENANCE INSTRUCTIONS

TROUBLESHOOTING GUIDE

POSSIBLE CAUSE(S)
Grit in tool; tool gummed up
No oil in tool
Low air pressure
Air hose leaks
Damaged cut-off disk

TOOL SPECIFICATIONS

CORRECTIVE ACTION
Clean the air motor inside the tool with
WD-40® (see "user maintenance" section).
Add 4-6 drops of air tool oil into the air inlet of
the tool (see "user maintenance" section).
Adjust compressor regulator to 90 PSI.
Tighten and seal hose fittings with Teflon® tape
if leaks are found.
Replace cut-off disk.
20,000
4.0 SCFM @ 90 PSI
1/4" NPT (female)
3"
3/8"
90 PSI
5 - ENG
D
Air tool oil
Male plug
Air inlet port