After Use - BGS technic 9337 Manual De Instrucciones

AFTER USE

•
Before you put down the tool, switch off the motor and ensure that all moving parts have come to
a complete standstill.
•
After switching off the tool, never stop the rotation of the accessory by a lateral force applied
against it.
DESCRIPTION
A Speed regulator
B Drive shaft locking knob
C On/Off switch
D Polishing disc
PREPARATION
•
Mount the handle in upright position onto the machine and tighten it with the two supplied inner
hex screws and the 6 mm hex spanner.
•
Push the knob (B) for locking the drive shaft.
•
Turn the inner thread of the polishing disc in clockwise direction onto the outer thread of the drive
shaft and hand-tighten it.
USE
•
Mounting of accessories
o disconnect the plug
o simply mount polishing hood (E) onto polishing disc (D)
o for removing accessories handle vice-versa
•
Before using the tool
o ensure that accessory is correctly mounted and firmly tightened
o check if accessory runs freely by turning it by hand
o test-run tool for at least 30 seconds at highest no-load speed in a safe position
o stop immediately in case of considerable vibration or other defects and check tool to
determine the cause
•
On/Off
o switch on/off the tool by pulling/releasing trigger (C).
•
Electronic soft-start
o Ensures reaching the maximum speed smoothly without a sudden impact when tool is
switched on
•
Switch locking for continuous use
o pull trigger (C)
o press knob (G) with your thumb
o unlock the switch by pulling again trigger (C) and then releasing it
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
E Polishing hood
F Ventilation slots
G Locking knob on/off switch
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed