Publicidad
Enlaces rápidos
Step 6.
Mount
cabinet pull-out to adjacent cabinet 1 through pre-drilled holes from
inside of cabinet.
Paso 6.
Monte el armario de relleno deslizante en el armario 1.
Étape 6. Monter le module coulissant sur l'armoire adjacente 1.
Step 7.
Mount
cabinet pull-out to adjacent cabinet 2.
Paso 7.
Monte el armario de relleno deslizante en el armario 2.
.
Étape 7. Monter le module coulissant sur l'armoire adjacente 2.
.
Step 8.
Remove front mounting strap.
Paso 8.
Retire la banda de montaje delantera.
Étape 8. Enlever la sangle d' e xpédition frontale.
Step 9.
Attach face frame and onlays (not provided).
Paso 9.
Instale el bastidor delantero y las chapas (no se incluyen).
Étape 9. Attacher le cadre avant et les pièces apposées (non fournis).
NOTE:
You can attach one continuous onlay or two separate pieces as
these units slide independent of each other.
NOTA:
Usted puede unir un applique continuo o dos pedazos separados
mientras que estas unidades deslizan independientemente.
NOTE : Vous pouvez attacher un onlay continu ou deux morceaux séparés
pendant que ces unités glissent indépendamment.
12400 EARL JONES WAY • LOUISVILLE, KY 40299 • 800 626 1126
www.rev-a-shelf.com
3
.
).
Fig 8
Fig 9
04/08
432FH Series Filler Pull-Out Instructions
Instrucciones del armario de relleno deslizante – Serie 432FFH
Directives de montage du module coulissant série 432FH
I-432FH-R
Publicidad
Manuales relacionados para Rev-A-Shelf 432FH Serie
Resumen de contenidos para Rev-A-Shelf 432FH Serie
- Página 1 Usted puede unir un applique continuo o dos pedazos separados mientras que estas unidades deslizan independientemente. NOTE : Vous pouvez attacher un onlay continu ou deux morceaux séparés pendant que ces unités glissent indépendamment. 12400 EARL JONES WAY • LOUISVILLE, KY 40299 • 800 626 1126 www.rev-a-shelf.com I-432FH-R 04/08...
- Página 2 Position du montage du milieu Step 5. Locating the filler assembly vertically is unique for each installation. It is recommend that the adjoining cabinet be Keep installation screws Step 1. Note: Do Not remove front mounting strap. measured and marked in order to pre-drill the cabinet before attachment. Pre-drill holes should be located 5” & 17” away between the horizontal plywood to Install scribe rails to filler pull-out using from the front of the face frame.(See fig. 4) Vertical measurements are according to the vertical placement of the unit. For ensure that the tips of the screws will not collide with small finish nails or brads. (See fig. 1 a & b). actual safe vertical locations for screw installation see figures 4, 5 & 6. Note: It is important to adhere to these attachment the ball bearing slides.