Replaceable Parts; How To Charge - Yvolution NEON NITRO 8 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Warning!
Dangerous slopes
7
Riding slopes exceeding a 15° angle is highly dangerous as it may cause loss of control and
damage to the product as well as serious injury.
Dismount
8
Lean back gently to decelerate and allow the board to slow to a standstill. To dismount remove your
foot from the pressure pad area by rolling your foot onto the toe or heel . The board will then stop
and lower you to the ground.
Jumping off
9
Otherwise come to a stop and jump both feet off the board at the same time, or lean towards your
toes and allow the board to fall over, tipping you onto the ground.
The foot sensor pad
10
The front foot pad is pressure sensitive . If you move your entire foot away from the sensor pad the
power will cut off. This can help you dismount the product.
Tip: Avoid repositioning your feet while riding
Trolley wheels
11
The trolley wheels at the tail end do not touch the ground during normal use
To engage the wheels, lift the handle at the front and drag the Nitro 8 behind you.

REPLACEABLE PARTS

Skid plates
12
The skid plates at both ends of the product are removable and replacements can be purchased at
www.neonlyghts.com
NOTE: The 3 screws on the front plate and the 2 screws on the back plate must be removed before
replacing the parts. When reattaching the replacement parts make sure not to over tighten the
screws as this may damage threads.
13
Wheel cover
If damaged, a replacement wheel cover can be purchased at www.neonlyghts.com.
Warning!
The cover MUST be in place before the product is used or turned on
NOTE: The 4 screws on the wheel cover must be removed before replacing the parts. When
reattaching the replacement parts make sure not to over tighten the screws as this may damage
threads.

HOW TO CHARGE

14
Connect the charger to an AC supply and then to the NEON NITRO 8 charging port.
The charger will display a red light.
A green light will appear when the battery pack is fully charged. The charger will automatically
stop charging.
Unplug the charger from the wall. Then unplug the charger from the NEON NITRO 8.
EN
5

Publicidad

Tabla de contenido
loading

Productos relacionados para Yvolution NEON NITRO 8

Tabla de contenido