Set-Up And Operation - Denios SpillGuard Manual De Instrucciones

Certificate
FM certificates
*Operational temperature range
The recommended operational temperature
range is the basis for the specified service
life of 5 years. SpillGuard may also be used
at a temperature down to max. -10°C. Long
exposure to low or high temperatures or high
levels of humidity can shorten the battery life.
Repeated false alarms may be triggered if the
temperature fluctuates around the dew point.

5. Set-up and operation

Symbols:
Audible signal tone
Visual signal
LED
5.1. Switching on and calibrating
SpillGuard®
Position SpillGuard® at the lowest point
1.
of the spill sump with the sensor surface
towards the bottom.
BVS 19 ATEX E 077
IECEX BVS 19.0073
FM 20 US 0051
FM 20 CA 0023
Press and hold the button until the signal
2.
tone is heard.
1 beep
LED flashes quickly
LED
The calibration process is complete after
3.
approx. 30 seconds.
2 beeps
LED flashes once a minute
LED
SpillGuard® is ready for operation.
5.2. Calibration for a new location
When installing SpillGuard® in a new location
proceed as follows:
Press and hold the button until the beep
1.
is heard to switch off SpillGuard®.
1 beep
Position SpillGuard® in the new location.
2.
SpillGuard® Quick Guide | 271433 | Rev. 2
19/42