Publicidad
Idiomas disponibles
Idiomas disponibles
will be under high power. If you wish to stop the heater, press the power button again when it's working under
high power.
2.
Timer button
Press the timer button once the icon "
or "-" to set your desired time (1-24 hours). It will be in effect after 5 seconds. Please note no operation display
will be shown on the front glass panel then. If you do not set the timer, the heater will work continuously with
no time limit.
Press the timer button under standby condition and then the button "+" or "-" to set your desired time (1-24
hours). It will be in effect after 5 seconds. The icon "
on the glass panel. If no further operation after setting for approximately 60 seconds, the appliance will be
locked with icon "
have passed. The glass panel will display the remaining hours during counting down.
3.
Up & Down
After the power button is pressed to start setting the heater, the appliance is in default under temperature
mode. You can press button "+" or "-" to adjust the temperature from 5°C - 35°C (default temperature setting is
35°C). Heater will be in effect after 5 seconds. You can also press the up & down buttons to adjust your desired
timer.
Please note:
1.
The heater will turn off the heating element automatically once the ambient temperature (room
temperature) reaches the set temperature. The heater will be turned on automatically when the ambient
temperature falls below the set temperature.
2.
The appliance usually displays the ambient temperature on the screen from 0°C - 49°C.
3.
After setting, if you do not press any button for approximately 15 seconds, the icons on the LED display
will light out; only the icon "
4.
The appliance will be locked by itself with no operation for approximately 60 seconds. Icon "
on display once you resume to set your heater. Press the buttons "+" & " -" together to unlock / lock the
appliance.
REMOTE CONTROL
1.
On/off button
Press the "on/off" button once to turn on the heater. The heater will be put into a low power mode and the
graphic display will display the room temperature. Press it one more time, the heater will be turned off. The
heater will be put into a standby mode.
" and "H" light up on the front glass panel. Then press the button "+"
" appear on the glass panel. The appliance will not start working until the setting hours
" is on.
" and "H" will be lighting up; icon "
" will be flashing
" will show
Publicidad
