Cleaning And Care; Wall Installation - Klarstein 10031470 Manual Del Usuario

When the door is opened, the light under the temperature adjuster will turn on automatically. The temperature
range for cooler is 12"C to 18"C. When the temperature is set on one certain point and the temperature inside
reaches this point, the automatic temperature control system begins to work and the cooling system goes into
linear temperature keeping status.
Note: Wait 3-5 minutes before restarting if you unplug the cooler. The unit may fail to operate properly if
restarted too quickly.
• Cleaners: Never use harsh, abrasive cleaners, heavy-duty cleaners, or solvents on any surface.
• Exterior: Wipe with damp, sudsy cloth, rinse and dry. For stubborn stains and for periodic waxing, use silicon
wax.
• Cooler Section: Wash shelves and other removable parts in warm sudsy water, rinse and dry. Wash interior
with baking soda solution (3 tablespoons to I liter of water) or warm sudsy water, rinse and dry.
• Magnetic Door Seals: Wash with warm sudsy water.
• The Finishing Touch: Replace all parts and return thermostat dial to desired setting.
The wall to fix the unit must be reinforced concrete wall or the wall which can bear the weight of the Wall-
hanging unit. The place to fix the unit should be close to electricity outlet which is convenient to plug the power
cord.
1
2
9

Cleaning and Care

Wall Installation

Use the Percussion drill to drill 3 holes with a diameter of 6 mm in the
wall, the depth of the holes Is about 30 mm, the distance between each
hole is about 160 mm. (It is recommended to put the Wall Bracket In the
wall to mark the position of the Installed holes before drill.)
Get the Expansion Plug from the plastic bag, and Install Into the drilled
holes In the wall.