Battery Tender Portable Power Pack Manual Del Usuario página 3

5V USB OUTPUT PORT
1) The 5V 2Amp USB output port can be used for charging your cell phone, tablet, PSP,
PDA, MP3/MP4 etc.
2) Connect your device to the Portable Power Pack™ using the appropriate cable and push
the ON/OFF button on the Portable Power Pack™ to start charging your device. The
battery level lights will also illuminate on the Portable Power Pack™.
3) After your device is charged remove the USB cable from Portable Power Pack™.
4) The Portable Power Pack™ will automatically shut down and the battery level lights will
extinguish.
5) Make sure all appliances are disconnected from the USB Output port and the Portable
Power Pack™ is off before placing back in storage or charging.
WARRANTY
The Portable Power Pack™ comes with a twelve (12) month limited warranty against defects
or failure within one (1) year from purchase.
THIS LIMITED WARRANTY IS VOID under the following conditions:
1) The product is misused, subjected to careless handling, or operated under
conditions of extreme temperature, shock, or vibration beyond our recommendations
for safe and effective use.
2) The product is disassembled or repaired by anyone who is not a factory authorized
service representative.
3) The product was purchased from an unauthorized source. Warranty is not
transferable from original purchaser.
4) Any physical damage to the Portable Power Pack™ or any accessories occurring
after purchase.
5) Any modifications to the Portable Power Pack™ or accessories.
6) Any corrosion including salt water
If you believe your Battery Tender® product is defective at any time during the
specified warranty period, go to
service.
.
www.batterytender.com/warranty for warranty
5
12 V mit Lithium-Batterien
Portable Power Pack™ - Leistungsmerkmale
LEDs der
Batterieladestands-
anzeige
LED
Steckbuchse für das
Krokodilklemmenmodul
Portable Power Pack™ - Zubehör
Krokodilklemmen
Wandsteckdosen-Ladeadapter
(länderspezifisch)
Zigarettenanzünder-Ladeadapter
Portable Power Pack™
Eingang 14 V, 1 A
zum Laden
USB-Ausgang
(5 V, 2 A)
EIN/AUS-
Testschalter
LED-EIN/AUS-
Schalter
6
