Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Measure the extra thread length
c)
(length X) protruding into the socket
X
c)
VI MOUNTING T HE VALV E
Apply silicone adhesive on the thread of the
a)
valve seat (1.1) (Never use Epoxy adhesive
as it may damage the gasket) to ensure
sealing between the external thread of the
valve seat and the internal thread of the
socket. Then use the 5 mm hex wrench (3) to
re-assemble the valve seat (1.
flat gasket (2). Take care that the flat gasket
be compressed enough.
b)
Screw the valve head (1.
(1.
)
1
VII CL EANING
a)
Unscrew the valve head (1.
Carefully remove the membrane (1.
b)
the cap (1.
). Clean all the components with
21
water and mild detergent. Keep the flap
(1.
) pressed while cleaning air passages.
22
Re-assemble the membrane (1.
c)
care to position it in the direction shown on
the diagram.
d)
Screw the valve head (1.
seat (1.
)
1
VIII RECYCLING
The 1S162 valve includes parts in plastics, silicone and aluminium. Each of these items must be recycled according to the laws in force .
IX DISCLAIM ER
The manufacturer's liability for this product is not involved if the product is not used properly or if the instructions are not followed.
No liability can be accepted for damages that are caused by the interaction of this valve with other components of the prosth esis.
X DECLARATION OF CONFORMITY
This product complies with the requirements of directive 93/42/CEE for medical devices. According to the classification crite ria (Annex IX of the direc-
tive), the product belongs to class I. Moreover, the manufacturer declares to comply with Annex VII of the directive for EC m arking procedures.
d)
Remove the assembly from the socket
e)
Remove the flat gasket (2) from the
valve seat (1.
d)
2
e)
) fitted with its
1
) on the valve seat
2
a)
)
2
) from
23
a)
), taking
23
) on the valve
2
c)
)
1
1.
1
3
2
1.
1
1.
2
1.
23
6, rue de la Redoute - 21850 - SAINT APOLLINAIRE -FRANCE
Tél: 33 (0)3 80 78 42 10 - Fax: 33 (0)3 80 78 42 15
ht.orthopedie@proteor.com www.proteor.com
f) On the seat valve (1.
), cut the extra
1
thread (length X) with a hacksaw (4).
Trim carefully and remove all the chips.
4
1.
1
X
f)
1.
1
b)
b)
1.
d)
PROTEOR
1S16299-1216 4/8
1.
2
1.
23
21
1.
1
1.
2
Publicidad
Tabla de contenido
