Alessi GV09 Inka Instrucciones página 5

with running water and dry them carefully.
We recommend you not to use detergents
so as to avoid altering the aroma of the
coffee. For normal cleaning we recommend
you to avoid taking the heat resistant glass
out of the thermoplastic resin support.
In order to clean the filter perfectly, we
recommend you to disassemble it from
time to time and clean it thoroughly,
especially if the coffee maker has not been
used for a long time. Unscrew the filter by
turning it around its axis (E). Separate the
three pieces making up the filter and wash
them carefully with running water. Dry and
reassemble the filter as shown in figure 6.
SPARE PARTS
The following pieces are considered spare
parts. In the event of loss or breakage you
can obtain them from your dealer, quoting
the code number shown in brackets.
Container in heat resistant glass for 8-cup
coffee makers (35741)
Mesh filter for 8-cup coffee makers
(GV09/RETE)
REPLACING THE HEAT RESISTANT
GLASS
When replacing the glass we recommend
you to ALWAYS WEAR PROTECTIVE
GLOVES.
Take the cover and filter out of the heat
resistant glass.
Before removing the heat resistant glass,
leave the press-filter immersed hot soapy
water for a few minutes.
Turn the glass upside down and press down
on the heat resistant from above.
ATTENTION: hold the press-filter as shown
in figure 6.
Make sure you insert the new glass with
the lip positioned correctly (Figure 7).
Fig. 2
Fig. 3
Fig. 4