GE Advantium JX2200 Instrucciones De Montaje página 2

ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN
2 UNDER-THE-COUNTER (UTC)
MOUNTING BRACKET INSTALLATION
NOTE: For UTC models PSB1200, PSB1201 and
ZSC1201 only.
A
Open the accessory drawer so you have access
to the top bracket.
B
Remove the three screws securing the top bracket.
C
Install the new UTC mounting bracket using the
screws removed previously.
D
Close the drawer and proceed with
the installation.
3 ASSEMBLING THE OVEN TO DRAWER
A Place storage drawer on a surface with the front
of drawer hanging over the edge of the surface.
Not placing the front edge of drawer over the edge
of the surface may result in damage to the drawer
since the front edge of drawer hangs below the
bottom of drawer.
B
Place the oven on top of the storage drawer. Make
sure that the back and sides of the oven align with
the back and sides of drawer.
NOTE: The bottom of the oven side flanges will sit
directly in front of the top of the storage drawer
side flanges.
Printed in Korea
ASSEMBLING THE OVEN TO DRAWER
(cont.)
C
Remove the front two bottom screws on each side
of the oven and the top center screw on each side
of the storage drawer.
D
Place the side supports into the tabs on the drawer
and secure using the screws supplied and the
screws removed in Step C.
Side
Support
120v only
E
The oven and storage drawer assembly is now
ready to be installed. Return to the Advantium 120V
or 240V Built-In SpeedCook Oven Installation
Instructions to complete the installation.
2