Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
GE Consumer & Industrial Appliances
Assembly Instructions
Advantium
JX2200, JX2201, ZX2201
BEFORE YOU BEGIN
Read these instructions completely and carefully. Read
the Installation Instructions for the Advantium 120V or
240V oven completely and carefully for cutout dimen-
sions and step-by-step instructions.
IMPORTANT
—
local inspector's use.
IMPORTANT
—
and ordinances.
NOTE TO INSTALLER:
•
instructions with the Consumer.
NOTE TO CONSUMER:
•
your Advantium 120V or 240V Oven Owner's Manual
for future reference.
SKILL LEVEL:
•
Installation of this appliance requires
basic mechanical skills.
COMPLETION TIME:
•
of an Advantium 120V or 240V oven.
• Proper installation is the responsibility of the installer.
• Product failure due to improper installation is not
covered under the Warranty. See the Advantium
120V or 240V Oven Owner's Manual for warranty
information.
MODELS AVAILABLE
Profile Models:
JX2200BB–Black
JX2201SS–Stainless Steel
Monogram Models:
ZX2201SS–Stainless Steel (for installation above 36" only)
NOTE: Advantium 240V model ZSC2202SS and
Advantium 120V model ZSC1202 CANNOT be
installed with an accessory storage drawer. See
Installation Preparation Without an Accessory Storage
Drawer in the Installation Instructions for these models.
®
Built-In Accessory Storage Drawer
Save these instructions for
Observe all governing codes
Be sure to leave these
Keep these instructions with
One hour with the installation
SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE
PRODUCT DIMENSIONS AND CLEARANCES
Allow 15" Clearance
When Fully Open
NOTE: Appearance will vary by model.
TOOLS REQUIRED
• #2 Phillips screwdriver
PARTS SUPPLIED
• Side supports (2)
• Brass screws (8)
• Color-matched screws (5)
1
REMOVE PACKAGING AND PARTS
• Remove the drawer from the carton.
• Remove all packing material and tape.
• Open the drawer and remove any parts inside.
• Locate parts.
Assembly Instructions
Screws
(6 required,
2 extra)
5"
• Under-the-Counter
Mounting Bracket (1)
Side Supports (2)
Under-the-Counter (UTC)
Mounting Bracket
Color-Matched
Screws
(4 required,
1 extra)
MFL06213304 49-40594 12-08 JR
Publicidad
Manuales relacionados para GE Advantium JX2200
Resumen de contenidos para GE Advantium JX2200
- Página 1 GE Consumer & Industrial Appliances Assembly Instructions Advantium ® Built-In Accessory Storage Drawer JX2200, JX2201, ZX2201 BEFORE YOU BEGIN PRODUCT DIMENSIONS AND CLEARANCES Read these instructions completely and carefully. Read 5” the Installation Instructions for the Advantium 120V or 240V oven completely and carefully for cutout dimen- Allow 15”...
- Página 2 ASSEMBLY TO ADVANTIUM BUILT-IN SPEEDCOOK OVEN ASSEMBLING THE OVEN TO DRAWER UNDER-THE-COUNTER (UTC) (cont.) MOUNTING BRACKET INSTALLATION Remove the front two bottom screws on each side NOTE: For UTC models PSB1200, PSB1201 and of the oven and the top center screw on each side ZSC1201 only.
- Página 3 GE Consumer & Industrial Appliances Instrucciones de montaje Cajón de almacenamiento de accesorios empotrado Advantium ® JX2200, JX2201, ZX2201 ANTES DE COMENZAR DIMENSIONES Y ESPACIOS DEL PRODUCTO Lea estas instrucciones por completo y con detenimiento. 5” Lea las Instrucciones de instalación del horno Advantium de 120V o 240V por completo y con detenimiento sobre las dimensiones del recorte y las instrucciones paso a paso.
- Página 4 MONTAJE EN UN HORNO DE COCCIÓN RÁPIDA EMPOTRADO ADVANTIUM CÓMO MONTAR EL HORNO AL CAJÓN INSTALACIÓN DE SOPORTE DE (cont.) MONTAJE BAJO EL MOSTRADOR (BEM) Quite los dos tornillos inferiores frontales de cada NOTA: Sólo para modelos BEM PSB1200, PSB1201 lado del horno y el tornillo central superior sobre y ZSC1201.