Directions For Use - Masimo rainbow RC-EXT Instrucciones De Uso

Ocultar thumbs

página de 72

/ 72
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

rainbow® Extension Cable

RC-EXT

Reusable

Prior to using this Cable the user should read and understand the Operator's Manual for the Device or

Monitor, the Directions for Use for the Sensor and Cable and this Directions for Use.

DESCRIPTION

The rainbow® Extension Cable, RC-EXT, is designed for use with Masimo M-LNC or RC patient cables on

Masimo or Masimo compatible pulse oximetry systems. When used with M-LNC patient cables, the RC-EXT is

able to provide Masimo SET® (SpO

to provide Masimo rainbow SET™ (SpO

WARNINGS

• Always refer to the oximeter module operator's manual for complete instructions or additional

instructions.

• Ensure the cable is physically intact, with no broken or frayed wires or damaged parts. Visually inspect the

cable and discard if cracks or discoloration are found.

• All sensors and cables are designed for use with specific monitors. Verify the compatibility of the monitor,

cable and sensor before use, otherwise degraded performance and/or patient injury can result.

• Carefully route patient cable to reduce the possibility of patient entanglement or strangulation.

• Failure to properly connect the sensor or the oximeter module to the cable will result in intermittent

readings, inaccurate results, or no reading.

• To avoid damage to the cable, always hold it by the connector rather than the cable when connecting or

disconnecting either end.

• To prevent damage, do not soak or immerse the sensor or cable in any liquid solution. Do not attempt to

sterilize the cable or sensor.

• Do not attempt to reprocess, recondition or recycle Masimo sensors or patient cables as these processes

may damage the electrical components, potentially leading to patient harm.

INSTRUCTIONS

NOTE: The maximum length for the sensor, cable and extension cable combination is 15 feet.

Connecting

to the Patient Cable

Refer to Fig. 1A. RC-EXT with protective cover: Properly orient the RC-EXT connector (1), insert the

patient cable connector (2) to the RC-EXT connector and completely close the protective cover of the

RC-EXT (3).

Refer to Fig. 1B. RC-EXT without protective cover: Properly orient the RC-EXT connector and insert the

patient cable connector to the RC-EXT connector.