associating the wireless device
TWO-ZONE CONTROL MODULE
• Check that the Repeater is powered
up.
• Check that the Receiver is powered up.
• Press the Repeater button until the red
led (fi g. 8) starts fl ashing slowly. The Re-
peater is now in association mode.
• Press the receiver button until the red
led starts fl ashing slowly.
Keep holding the button down; the red
led will start fl ashing quickly to indicate
that association with the Repeater is in
progress.
• If the procedure has terminated suc-
cessfully, the red led on the Receiver
and the Repeater will go out.
• Repeat the association procedure
between the Zone Module and the Re-
ceiver.
Fig. 8
BUTTON
RED LED
14 - GB
MULTIZONE CONTROL MODULE
• Check that the Repeater is powered
• Check that the Receiver is powered up.
• Press the Repeater button until the red
• Press the receiver button until the red
• If the procedure has terminated suc-
• Repeat the association procedure
GREEN LED
up.
led starts fl ashing slowly. The Repeater
is now in association mode.
led starts fl ashing slowly.
Keep holding the button down; the red
led will start fl ashing quickly to indicate
that association with the Repeater is in
progress.
cessfully, the red led on the Receiver
and the Repeater will go out.
between the Zone Module and the Re-
ceivere.