Casals AG2302000A Instrucciones Originales página 4

Power tools or garden power tools are dangerous
in the hands of untrained users.
Use the power tools or garden power tools, in ac-
cordance with these instructions and in the manner
intended for particular type of power tools or gar-
den power tools, taking into account the working
conditions and the work to
be performed.
Use of the power tools or garden power tools for
operations different from intended could result in a
hazardous situation.
Have your power tools or garden power tools
serviced by a qualified repair person using only
identical replacement parts. This will ensure that
the safety of the power tools or garden power tools
is maintained.
Special safety instructions
1. Do not use the machine without the protective
cover. Ensure that this is fitted correctly.
2. Check whether the mounting flanges and the
disk have been inserted correctly and are not
damaged.
3. Ensure the speed of the machine is high enough
for the accessories. Allow a newly mounted
abrasive wheel to run without load for at least thirty
seconds. Please keep the safety instructions in a
safe place.
4. Please ensure that the voltage of the main
power supply corresponds to that stated on the
type plate. The tool is equipped with a two pole
lead and plug.
5. Only use a suitable extension cable when this
is absolutely necessary. The use of an un-suitable
extension cable carries with it the danger of fire or
an electric shock. If an extension cable has to be
used ensure that it is correctly wired and in good
condition.
6. Your machine is double insulated. This means
that two completely independent types of insula-
tion prevent you from coming into contact with
live metal parts. This measure represents a high
degree of protection against electric shock.
7. When working with this machine it is advisable
to use ear protection.
Description
1. Lock button
2. Housing handle
3. On and off switch
4. Side handle
5. Protective cover
AG2302000A_IM.indd 4
6. External flange spanner
7. External flange with thread
8. Internal flange
9. Drive shaft
10. Gear box
Before initial use
Mounting the side handle
During operation keep one hand on the housing
handle (5) and the other on the other side handle
(3). In order to mount the side handle, screw it into
the screw hole of the gear box.
Correct fitting of the protective device
Ensure that the protective cover (6) is fitted cor-
rectly and that the fixing screws have been tight-
ened. Before tightening the fixing screws, turn the
on and off switch (1) to the (0) position and remove
the main plug.
Grinding and surface processing
In order to grind surfaces you should use a coarse
abrasive disk with a sunken centre.
You can use abrasive disks with a diameter of
125mm to 230mm. the maximum thickness is
6mm.
Cutting metal
In order to cut rods, tubes and metal parts you
should use a cutting off wheel. You can use wheels
diameter of 125mm to 230mm. The maximum
thickness in this case is 3mm.
Cutting stone material
When cutting stone material you should use a flat
cutting off wheel. You can use wheels with a diam-
eter of 125mm to 230mm. Always approach the job
at the same angle at which you would like to cut.
Maintain this angle during cutting and do not exert
any side pressure on the wheel.
Inserting the wheels/disks
Please proceed as follows when inserting the
wheels/disks:
1. Before mounting remove the main plugs from
the socket and move the on and off switch
(1) To position (0). Ensure that the protective de-
vice is correctly installed.
2. Place the internal flange (10) on the drive shaft
(2). Ensure that it is in contact with the 2 flat areas.
3. Now place the abrasive disk on the drive shaft
(2) and the internal flange (10). Ensure that it is
2019-03-01 08:45:03 AM