Casals AG2302000A Instrucciones Originales página 5

correctly in place.
4. Now attach the external flange with the thread
(9), ensuring that it is facing the right direction ac-
cording to the type of disk/wheel used. In the case
of abrasive disks, the flange (9) is inserted with the
higher side pointing towards the disk.
In case of cutting off the wheels, the flange (9)
is inserted with the flat side pointing toward the
wheel.
5. Press and hold the lock button (7) so that the
drive shaft cannot turn and then tighten the exter-
nal flange (9) with the external flange spanner (8).
Abrasive disks
1. Ensure that the speed to which the machine is
set is sufficient for the accessories chosen.
2. Use only an abrasive disk with a diameter of up
to 230mm.
3. Before mounting the disk, remove the main
plugs from the socket and push the on and off
switch (1) to position (0).
4. Place the internal flange (10) on to the drive
shaft (2).
5. Place the abrasive disk on the drive shaft (2)
and ensure that it is correctly in place.
6. Attach the external flange with the thread (9)
and tighten it as described above with the external
flange spanner (8).
NOTE: expect a rain of sparks when the disk
comes into contact with metal. While grinding,
always maintain the correct angle between the
disk and working surface of 15 ̋ . This produces and
avoids overloads.
Overload the motor of your right angle grinding
the ma-chine may be damaged when overloaded.
This results from excessive working pressure over
a prolonged period. Therefore you should try not
to accelerate your working speed by increasing
pressure on your machine. The abrasive disk work
more efficiently if only slight pressure is exerted on
your machine, thus avoiding a drop in the grinding
speed.
Maintenance
1. The protective cover air slits and motor housing
should be kept as free of dirt and dust as possible.
2. Rub off the device with a clean cloth or use
compressed air at a low pressure to blow out any
dust or dirt. Excessive amounts of metal may result
in electricity from the internal components being
conducted onto exposed metal parts.
3. Do not subject the grinding machine to any over-
load. Overloading will lead to a reduction in the
speed and performance and cause the machine to
AG2302000A_IM.indd 5
overheat. If this should happen switch the grinding
machine off and let it cool down for approximately
30 minutes or to room temperature.
NOTE:
Turning off the grinding machine while it is being
subjected to a load will reduce the working life of
the operating switch.
Cleaning and care
1. Before cleaning the machine remove the main
plugs from the socket and turn the on and off
switch (1) to position (0).
2. For cleaning purposes only use a slightly damp
but not wet cloth.
3. Do not use abrasive additives (petrol, turpentine
etc.) as these may damage the plastic housing.
4. A mild soap is suitable for cleaning the ma-
chine.5. Ensure that no moisture is allowed to get
in-side the machine.
6. After cleaning wipe the machine with a dry cloth.
2019-03-01 08:45:04 AM