sunjoe SJG4100LP Manual Del Operador página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Testing the Propane Cylinder
Before connecting the cylinder with the generator, make sure
to test the cylinder for leakage. Follow the instructions below.
1. Make sure the propane cylinder is disconnected from the
propane hose and regulator.
2. Make leakage solution by mixing 1 part liquid dish soap
and 3 parts water.
3. Using a clean paint brush, brush the soapy solution over
areas indicated by arrows in Fig. 13.
Fig. 13
4. If bubbles show up, there is a leak. Do not use or move
the propane cylinder. Contact a gas supplier or the fire
department!
5. If you see, smell, or hear the hiss of escaping gas from the
propane cylinder:
Move away from propane cylinder.
Do not attempt to correct the problem yourself.
Call your local fire department.
Connecting/Installing the Propane
Cylinder
Propane is highly flammable and may ignite unexpectedly
when mixed with air. The propane cylinder used with this
generator must meet the following requirements:
• Constructed and marked in accordance with all
specifications required by related law and regulations.
• Measurements: 12 in. diameter x 18 in. tall with 20 lb.
maximum capacity, or 12 in. diameter x 23 in. tall with 30 lb.
maximum capacity.
• Cylinder valve must have Type 1 connection device
compatible with the connector for the generator.
• Cylinder must be equipped with safety relief valve.
• Cylinder valve must have UL listed Overfill Protection
Device (OPD). This OPD safety feature is identified by a
unique triangular handwheel. Use only propane cylinders
with this type of valve.
• Arranged for vapor withdrawal and include collar to protect
propane cylinder valve. Always keep propane cylinder in
upright position during use, transport, or storage.
To install and connect the propane cylinder with the generator,
follow the instructions below.
1. Pull the handle lock pin ring and restore the handle to the
storage position. Remove the cap on the propane inlet,
and connect the propane connecting hose to the propane
inlet. Screw the locking nut on the hose clockwise tightly
with a wrench for a secure connection (Fig. 14).
Fig. 14
Cylinder
connecting
hose
Propane inlet
2. Lower the cylinder bracket completely. Place a propane
cylinder (not included) into the bracket, making sure the
bottom of the cylinder is placed securely in the opening
in the bracket. To secure the cylinder, place the cylinder
strap around the cylinder and connect to the hook on the
generator frame as shown (Fig. 15).
Fig. 15
Propane
cylinder
Cylinder bracket
Cylinder strap
3. Make sure the cylinder valve on the propane cylinder is
turned clockwise to its full off position. Hold the propane
connecting hose firmly and insert the nipple into the
cylinder valve (Fig. 16).
NOTE: Nipple must be centered in the cylinder valve.
14
Hook (on both
sides)

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Sjg4100lp-tv1

Tabla de contenido