Product Maintenance - Fellowes POWERSHRED 53C Manual Del Usuario

BASIC SHREDDING OPERATION
Continuous operation:
Up to 3 minute maximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
3 minutes will trigger a
30-minute cool down period.
TROUBLESHOOTING
PAPER JAM
1
2
Set to Reverse (R) Alternate slowly back and forth
for 2-3 seconds

PRODUCT MAINTENANCE

OILING SHREDDER
machine may experience diminished sheet capacity, intrusive noise when
recommend you oil your shredder each time you empty your waste bin.
FOLLOW OILING PROCEDURE BELOW AND REPEAT TWICE
1 2
* Apply oil
across entry
* Only use a non-aerosol vegetable oil in long
nozzle container such as Fellowes 35250
Go to Support Section at www.fellowes.com or see back page of manual for useful telephone numbers.
LIMITED PRODUCT WARRANTY
defects in material and workmanship and provides service and support for 2 years from the date of
from defects in material and workmanship for 5 years from the date of purchase by the original
consumer. If any part is found to be defective during the warranty period, your sole and exclusive
warranty does not apply in cases of abuse, mishandling, failure to comply with product usage
standards, shredder operation using an improper power supply (other than listed on the label), or service under this warranty, please contact us or your dealer.
PAPER OR CD/CARD
1
1 2
Plug in and put
disconnect power
switch in ON (I) position
4
3
and unplug
CLEANING AUTO-START INFRARED SENSORS
Paper detection sensors are designed for maintenance free operation. However, on rare occasions, the
sensors may become blocked by paper dust causing the motor to run even if there is no paper present.
(Note: two paper detection sensors are located in the center of the paper entry)
TO CLEAN THE SENSORS
1
3
Set to Reverse (R)
2-3 seconds shredder
3 4
or
paper entry and release entry and release
5 6
Gently pull uncut
paper from paper
(I) and resume
entry. Plug in
shredding
2
Locate Auto-start
infrared sensor
5
When finished shredding
)
Shredder doesn't start:
Make sure head is on basket correctly
Wait 30 minutes for motor to cool down
Remove and empty basket
.
3
4
Dip cotton swab in Using cotton swab, wipe
rubbing alcohol away any contamination
from the paper sensors
3