Outdoor Leisure TD100 Instrucciones De Ensamble

Check all items for shipping damage. If heater is damaged, promptly
inform dealer where you bought heater.
Remove all parts from carton. Carefully lay all items out for ease of
access during assembly.
Cabinet
Base
Top Cap
Estimated assembly time: 60 minutes
Tools required:
• #2 Phillips screwdriver
• 1/2", 5/16" and 7/32" Open end wrenches
Hardware packet provided with heater may contain more parts than
needed for heater assembly.
Hardware packet contains the following items shown on pages 8
through 11 in your owner's manual):
Electronic Ignitor (1), Ignitor Wire (1), Ground Wire (1), Valve Knob
(1), Propane Tank Retention Chain (1), Retention Hook (2), D Bat-
teries (2) and AA Battery (1).
Parts are referenced by designated letter throughout assembly
instructions. Hardware packet contains the following (quantity used
in parenthesis):
GAS LIGHT PATIO HEATER
ASSEmbLy InSTRucTIOnS
mOdELS Td100, Td102, Td104 & Td110
unPAckInG HEATER
Lightpost
Panels
Tank
Door
Burner
Assembly
Hardware Packet
You should have the following assembly parts:
Top Cap (1), Burner Assembly (1), Cabinet Base (1), Base (1), Base
Weight (1), Wheel (2), Base Cabinet Door (1), Lightpost Panel (4),
Deco Light Shroud (2), Upper Screen (4), Lightpost Top (1), Propane
Tank Retention Chain (1), Retention Hook (2), Hardware Package
Base
(1) (see pages 8 thru 11 in your owner's manual).
ASSEmbLy
Description
A 1 1/2" Screw (8)
B 7 mm Washer (8)
C 5/8" Screw (9)
D 5 mm Washer (9)
E 5/16" Hex Nut No. 10 (9)
F 3/8" Screw (20)
G 7/32" Hex Nut (20)
H 3/8" Self tapping screw (34) 119620-02
I 2 1/4" Hex Bolt (2)
J 12 mm Hex Nut (2)
B
E
A
F
C
G
D
H
Deco Light Shrouds
Lightpost
Top
Base
Weight
Light Shroud
Screens
Part No.
119619-01
119600-04
119619-03
119600-02
NPC-3C
119619-06
NPC-1C
HC4-18C
NPC-5C
I
J