Comelit UT1020 Manual De Programación página 12

◊ Lock-release: if a lock-release command is sent from a door entry monitor with an address that falls
within the values entered in the "From address" and "To address" fields, it triggers the event specified
in the "Activation" field
◊ Actuator control: if an actuator command is sent with an address that falls within the values entered in
the "From address" and "To address" fields, it triggers the event specified in the "Activation" field
• Activation: action triggered after the event specified in the "Action" field occurs
◊ Local output control: activates the output set in the "Output" field (SE output for the module or Relay
output for the module). NOTE: Module SE Output and/or module Relay Output must be set in the menu
"Outputs" > SE Output and/or Relay Output with "Function" > Lock-release and/or actuator
◊ Control on Ultra bus (UDB): activates the relay on the number keypad specified in the "Type" field
(Relay 1 or Relay 2)
◊ Actuator control: activates the actuator with the address specified in the "Actuator address" field
(from 1 to 255)
SELF ACTIVATION
This menu is used to authorise door entry monitors to use the self activation function.
SELF ACTIVATION
• Enable: enables the self activation function
• Duration (sec): set the desired duration of the function (from 10 to 60 seconds, default: 60 seconds)
CAMERA
This menu can be used to manage camera settings for the audio/video module
CAMERA
• LED adjustment: adjusts the brightness of the LEDs lighting the scene captured by the camera (from 0,
off, to 100, default: 70)
• Enable LED on self activation: if enabled, the LEDs lighting the captured scene will even come on in the
event of door entry monitor self activation (enabled by default)
• Mode: select the operating mode of the LEDs lighting the captured scene
◊ Auto: lighting comes on at night and switches off during the day (default)
◊ On: lighting always comes on, for every call
◊ Off: lighting is always off
MAINTENANCE
Restarting the device
To restart the module:
1. select it
2. right-click on the description (a pop-up with 5 sub-menus will appear)
12