Axor Starck 10030 Serie Instrucciones De Montaje página 7

Assembly
Important! The fitting must be installed, flushed
and tested after the valid norms!
1. Flush through the supply pipes.
2. Place the mixer including the sealing washer in
position on the basin / bidet.
3. Slip the slide washer, washer and collar nut over
the threaded base and tighten the collar nut by
hand.
4. Tighten screws.
5. Connect the supply pipes to the isolation valves;
cold right - hot left.
6. Connect the pull rod to the pop-up waste.
The hot and cold supplies must be of equal
pressures.
Technical Data
This mixer series-produced with water-
dimmer (flow limiter)
Operating pressure:
Recommended operating pressure: 0,1 - 0,5 MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water
temperature:
Rate of flow:
Test certificates
10030XXX/10050XXX:
Hansgrohe two handle mixers can be used together
with hydraulically and thermically controlled
continuous flow heaters if the flow pressure is at
least 0,15 MPa.
If the continuous flow heater makes any problems
or there comes not enough water, the waterdimmer
(flow limiter 5a) located behind the mousseur must
be removed.
English
Spare parts (see page 3 + 4)
1
2
3
4
5
6
7
8
9
10 lever arm cpl. 340 mm
Special accessories
X
XXX = Colors
000 chrome plated
810 satinox
max. 1 MPa
1,6 MPa
max. 80° C
65° C
7 l/min 0,3 MPa
WRAS
handle for cold / hot water
color-ring cold / hot water
handle fixing set
shut off unit
aerator cpl.
pull rod
connection hose 350 mm
connection hose 600 mm
fixing set cpl.
lever arm cpl. 290 mm
special tool set
(order as an extra)
®
96318X X X
96319000
94184000
94149000
94005XXX
94083XXX
13099000
14099000
13961000
96307000
96004000
58085000