Before First Use - MPM MKL-03 Instrucciones De Uso

l.
Fan mode indicator lights „Nor-
mal/Natural/Sleep"
2.
Horizontal louvre
3.
Vertical louvre
4.
Castors
5.
ICE BOX cooling cartridges
6.
Water evaporation filter
7.
Safety filter

BEFORE FIRST USE

1. Remove the air cooler from the box and discard all labels, stickers, plastic bags and filling
materials.
2. Inspect the air cooler carefully for damage which may have occurred in transport. If damage
is suspected, consult your reseller.
3. Verify that your power mains match the nameplate ratings of the air cooler.
4. Wash the ICE BOX cooling cartridges (5) with water on the outside, dry them, fill with water (if
they are empty), and refrigerate or freeze them until cold or frozen.
CAUTION! Never change the water in the ICE BOXES after the first filling! Only the first filling will provide the
best cooling performance: the Ice Boxes are filled with a cooling promoter in powder.
5. Install the castors (4) under the base. Two of the four castors feature lock levers which brake
the wheels.
6. Install the batterie CR2025 in the remote control (see Section CLEANING AND MAINTENAN-
CE).
CAUTION! The batterie CR2025 are not included with MKL-03.
USING THE AIR COOLER
1. Place the air cooler on a firm, flat and level surface.
CAUTION! Keep a clearance of 50 cm minimum around the air cooler.
CAUTION! The air cooler must be operated upright only.
2. Turn the lock lever (13) to the horizontal position at the back of the air cooler to release and
gently remove the water tank (8).
3. Place the cold ICE BOXES (5) in the water tank (8). If uses, the Ice Boxes greatly improve the
air cooling and humidifying performance. You can keep the air cooler cool the air without
interruption by using one of the Ice Boxes while refrigerating or freezing the other Ice Box.
4. Fill the water tank with cool and clean water until it reaches a level between the MIN and
MAX marks. Slide the water tank back into the air cooler and lift the lock lever (13) upright to
secure. You can add ice cubes to the water in the water tank.
5. Plug in the air cooler to the mains. When the aplliance is plugged to the mains, it will beep
briefly and the "Power" indicator light (1g) will be on.
6. Start the air cooler with the "ON/OFF" button (1a). The air cool starts running in the Fan mode
only (temporarily at "Mid" and then "Low").
8.
5 l water tank
9.
Drain plug
10. Handle
11. Power cord winding hook
12. Housing
13. Lock lever
14. Remote control
13