Westinghouse 6365900 Manual De Instrucciones

INSTRUCTIONS MANUAL
Limited Warranty:
This xture is warranted to be free from defects in material and workmanship for 5 years
(based on using 3 hours per day). If the product fails during the warranty period, return
defective product to retailer. Warranty terms and conditions of retailer apply. If replace-
ment product is not available at retail store, please contact consumersupport@westing-
houselighting.com or return the product in the original package with receipt to manufac-
turer at: 12401 McNulty Road, Philadelphia, PA 19154-1029.
CAUTION
1. SUITABLE FOR OPERATION IN AMBIENT NOT EXCEEDING 45°C.
2. SUITABLE FOR DAMP LOCATION.
3. THIS PRODUCT MUST BE INSTALLED IN ACCORDANCE WITH THE APPLICABLE INSTALLATION
CODE BY A PERSON FAMILIAR WITH THE CONSTRUCTION AND OPERATION OF THE PRODUCT
AND THE HAZARDS INVOLVED.
4. CAUTION – RISK OF FIRE.
5. ALL COMPONENTS IN THE LUMINAIRE SHALL NOT BE REPLACED OR SERVICED.
6. The electrical installation must be carried out in accordance with the current national electrical
regulations.
7. In the interests of electrical safety, a 30 mA residual current device (RCD not supplied) should be
installed in the supply circuit. This may be part of a consumer unit or a separate unit.
8. Isolate the electrical supply before connecting the power cord. Always take care of the working
load in the cables when multiple products are installed.
9. Do not allow the power cord to come into contact with hot surfaces, including the luminaire
shell or bodywork. The cord should be safely routed and secured.
10.This appliance must be grounded via the power cord plug and the electrical supply to the socket
and must be correctly connected to the ground point in the terminal box or consumer unit.
11.The product may get hot during normal operation. Keep the product surroundings clean to
allow natural ventilation and away from any ammables or explosives.
12.The product is heavy. Design and set up the installation structure properly to ensure the
strength of the entire setup, especially when multiple products are installed in your facility.
INSTALLATION
1. Fixed installation: Prepare the installation by referring to the drawing. Use two M10x20
hexagon bolts (optional accessory) through the two slots on the bracket to attach the
product onto a beam. Tighten the two adjustment screws after positioning the xture to
direct the light in the direction you desire.
2. Hanging installation: Insert the two rope rachet hangers through the two slots on the
bracket. Adjust the length of the rope ratchet hangers to achieve the desired xture position
for both the height and beam direction.
Packing list
Parts
LED xture with US power cord
M10x20 bolt suits
1/8'' rope ratchet
Star washer
Flat washer
1
Q'ty
1pc
2pcs
2pcs
2pcs
2pcs
ESF-WH-062