Vertical Setup; Squaring - Hexagon GeoMax ZEL400HV Manual Del Usuario

2.4 Vertical Setup

Vertical setup,
step by step

2.5 Squaring

Squaring, step by
step
Basic Operation
5. If you wish to move the laser beam to a specific point, briefly press key
(16) or (17).
6. To adjust the rotation speed, press key (14) or (15) continuously according
to the direction you wish. To stop the rotation, press once the opposite key.
7. To turn the laser off, press key (24).
No accessories are needed for this position. The ZEL400HV can be used directly
on the ground. However, it can be used on the mount for a better setup.
1. Flip up the retractable foot (7). Place the instrument in vertical position,
resting on this foot. Use the adjustable feet (8) to rough level the laser to
adjust the top bubble vial (13).
2. Switch the instrument on. Once the instrument is leveled, the head will
start rotating.
1. Put the laser on the ground and repeat the steps 1 and 2 for vertical use.
2. Stop the head rotation by pressing key (14) or (15).
3. To position the rotating vertical plane perpendicular to a reference line:
Coincide the arrow (5) located below the beam aperture with the index (6)
located above the retractable foot (there is also an index mark on the foot).
ZEL400HV | 10