Install Batteries; Connect Power; General Operation; Power - SOUNDMASTER highline iP4060BT Manual Del Usuario

Install Batteries

Note:
• You can only use AC power as power supply.
Batteries ( not supplied ) are for backup
purpose.
• If the system is unplugged or if a power
failure occurs, all setups of the unit will be
erased unless there are batteries in the unit
and don't change them at this time. Once
setups had be erased, please resetup all items
( tuner stations; Source... ) which you desire.
1 Open the batteries compartment.
2 Install two AAA batteries(not supplied) with
correct polarity and the install steps as
indicated.
3 Close the battery compartment.

Connect Power

Caution:
- Risk of product damage! Ensure that the
power supply voltage corresponds to the
voltage printed on the back or the underside
of the unit.
- Before connecting the AC power cord, ensure
you have completed all other connections.
Connect the AC power cord to the wall socket.

General Operation

Power

You can use all the functions on the top of the
unit or the remote control after connecting to
power supply (called Standby Mode).
Turn On
Press ON/OFF button to turn the system on from
standby mode.
Press ON/OFF/SOURCE to select different
functions.
• When turning the system on, the system will
continue in the mode it was in when it was
turned off last time.
Turn Off
Press and hold ON/OFF button on the unit or
press the button on the remote control again to
turn the system off and go to standby mode.
• If there is no signal under the DOCK, LINE IN and
BT mode, the unit will automatically switch off
within 15 minutes.
• Be sure to unplug the power cord from the
outlet when the system is not in use for an
extended period of time.

Set Time

The built-in clock shows the correct time in the
display.
1 Press and hold the CLOCK button on remote
or SNOOZE button on main unit for seconds,
hour indicator will blink.
2 Set the hour with / on remote or
 
on main unit.
3 Press CLOCK button on remote or SNOOZE
button on main unit to confirm.
4 Repeat steps 2-3 to set the minutes, day,
month and year.
• During Time Setup press the
select 12/24 hour format.
EN
/
H G
button to
B F
6
EN