Tire Pressure - Craftsman professional 247.88845 Manual Del Usuario

Tire Pressure

Before operating, check tire pressure. Refer to the tire sidewall for
exact tire manufacturer's recommended or maximum psi.
NOTE: If the tire pressure is not equal in both tires, the unit may not
travel in a straight path and the shave plate may wear unevenly.
aDjUsTMenTs
skid shoes
The snow thrower skid shoes are adjusted upward at the factory for
shipping purposes. Adjust them downward, if desired, prior to operat-
ing the snow thrower.
• For close snow removal on a smooth surface, raise skid shoes
higher on the auger housing.
CaUTion
It is not recommended that you operate this snow thrower on gravel
as it can easily pick up and throw loose gravel, causing personal
injury or damage to the snow thrower and surrounding property.
• Use a middle or lower position when the area to be cleared is
uneven.
NOTE: If you choose to operate the snow thrower on a gravel surface,
keep the skid shoes in position for maximum clearance between the
ground and the shave plate.
ASSEMBLY
Chute Tilt Control
Auger
Control
Auger
Control
Cable
To adjust the skid shoes:
1. Loosen the six hex nuts (three on each side) and carriage bolts.
Move skid shoes to desired position. See Fig. 8.
2. Make certain the entire bottom surface of skid shoe is against the
ground to avoid uneven wear on the skid shoes.
3. Retighten nuts and bolts securely.
Shift Lever
Figure 9
10
Figure 8
Drive
Control
Drive
Control
Cable