General Description - INIM Electronics Previdia Max IFM24160 Manual Del Usuario

Installation manual
1 About this manual
Manual code: DCMIIN1PIFM24160
Version: 1.30
2

General Description

The IFM24160 internal module supplies and distributes power through the CAN drive connection bar and
through the two outputs, OUT 1 and OUT 2.
In installations where several control panels are connected in a network, it is necessary to use an IFM24160
power-supply module for each control panel.
In installations where the control panel comprises more than one cabinet, you can install a power supply in
each cabinet. The total voltage available equals the sum of the voltages of each power supply added together
minus 1A for correct cable balance.
FPMCPU comes with:
• battery connection wire with thermal probe
• battery to battery connection wire
• 3 screws for securing the module to the grounding bar
• wire with eyelet terminal for connection to earth
• 1 ferrite
• Instructions manual
[A]
[B]
Mini USB port
Jumper connectors for enablement of the
[C]
ground-fault test
[D] OUT1
[E] OUT 2
[F] RELAY
Relay - voltage free contact
The indications in brackets below terminals OUT1, OUT2 and RELAY [D, E, F] show the respective factory
default settings.
IFM24160 LED
CAN
ON
MAINS
BATT
Power supply voltage
Maximum current draw from mains
Output voltage
Maximum output ripple
Maximum available current
Imax a (as per EN54-4)
Imax b (as per EN54-4)
About this manual
Figure 1 - IFM24160, page 1
Status LED
Supervised output
Colour
Blue
Green Module operating normally
Yellow Mains failure fault
Yellow Battery inefficiency or fault
IFM24160 module - technical specifications
Imin
[G]
[H]
L N
[I]
Hole for the grounding bar screw and for the wire with the
[J]
Input voltage
[K]
selector
[L]
On solid
Activity on the CAN communication BUS
Slow flashing: overload (system voltage draw is
Battery connector
AC Mains input terminals
Hole for the grounding bar screw and
for the earth conductor
eyelet terminal
230/115 V
CAN drive connector (opposite)
Flashing
excessive)
Fast flashing: PSU unit overheated
Fast flashing: system ground fault
230V~ (+10% - 15%)
115V~ (+10% - 15%)
50/60 Hz
1.1A @ 230V
2A @ 115V
27.6 V nominal
20 - 27.6 V
1%
5.2A
4A
4A
185mA
7